Body - Front License Plate Bracket Has No Holes
66 Front license plate bracket has no plate mounting holes
66 09 06
2016682/4
December 3, 2009.
Supersedes Technical Service Bulletin Group 66 number 09-01 dated February 18, 2009 for reasons listed below.
Affected Vehicles
Condition
306
Front license plate bracket has no provisional pre-cast holes to mount a license plate for North America. The holes found in the bracket are not for a
North American license plate.
Technical Background
Change in concept.
Production Solution
None. This license plate bracket will be supplied in this way in the future.
Service
1. For these cases, do not replace the license plate bracket. The replacement part also does not have the correct screw holes. The bracket supplied
with the vehicle will need to be modified. From a piece of cardboard fabricate a template. A manila folder works well. Cut the cardboard in exactly
the same shape as the rectangular impression in the bracket.
307
2. Take the license plate and center it in your template. Use a ruler since this centering must be exact.
3. Trace out the screw holes with a pencil.
4. Now place the template over the bracket and mark through the center of these holes with a sharp pick.
5. Drill a 3 mm hole in each of these marks. Use the screws provided with the bracket to mount the license plate.
Warranty
This TSB is informational only and not applicable to any Audi warranty.
Additional Information
308
All parts and service references provided in this TSB are subject to change and/or removal. Always check with your Parts Department and service
manuals for the latest information.
