Steering - Stiff Steering On Start-Up/Multiple DTC's May Be Set
48 Generation 3 power steering - steering stiff after engine start
48 13 37
2021189/4
February 28, 2013
Supersedes Technical Service Bulletin Group 48 number 11-17 dated October21, 2011 for reasons listed.
Vehicle Information
Condition
^ Steering feels stiff after engine start on vehicles with generation 3 steering.
^ The following entries may be stored:
^ DTC 16344 (14 control unit faulty)
^ DTC 16353 (14 control unit incorrect)
^ DTC 16355 (14 control unit incorrect)
^ DTC 16347 (07 no or wrong basic settings/adaptation)
^ DTC 16347 (14 control unit faulty)
Technical Background
Incorrect software.
Production Solution
New software, 3305.
Service
1. Follow all instructions in the attached TSB, 2011732 00 Software Version Management (SVM), operating instructions.
Page 304
2. Update the power steering software using the SVM action code as listed in the table shown, if necessary. The tester may display a note stating
that update programming must be performed on two control modules. The updates should be installed in the order proposed by the tester.
Tip: If the software is below 2901 (for example, 2301 or 2501), update it to 2901 first. Use SVM code 8P44A001 (for A3) or 8J44A001 (for TT).
After updating to 2901, use the SVM chart below to update to the newest software, 3305.
- After the SVM update, adapt power steering control module, J500 (44), through Guided Fault Finding.
- Calibrate Steering Angle Sensor G85.
Warranty
All warranty claims submitted for payment must be in accordance with the Audi Warranty Policies and Procedures Manual. Claims are subject to
review or audit by Audi Warranty.
Additional Information
All parts and service references provided in this TSB are subject to change and/or removal. Always check with your Parts Department and service
manuals for the latest information.
Page 305
Page 306
Page 307
Page 308
Page 309
Page 310
Page 311
Page 312
Page 313
Page 314
