Saturday, 12 September 2020

******** Audi Q5 Quattro (8RB) V6-3.2L (CALB) Technical DIAGNOSIS AND REPAIR # 971015 Date: 101020


Electrical - Erratic/Sporadic DTC's Set



97 DTCs, sporadic - contact check



97 10 15



2013504/7



October 20, 2010



Supersedes Technical DIAGNOSIS AND REPAIR Group 97 number 10-09 dated June 30, 2010 for reasons listed below.



645



AFFECTED VEHICLE



CONDITION



Sporadic fault memory entries stored in various control modules.



TECHNICAL BACKGROUND



Contacts may be widened (over 0.63 mm) by using incorrect pins or incorrect methods for current flow tests. Either action may cause intermittent



electrical connections. This may cause sporadic DTCs to be stored in various control modules.



PRODUCTION SOLUTION



Not applicable.



SERVICE



1. Check the contacts on the control module and connector.



a. Verify that all pins and terminals are securely clipped into the connectors.



b. Verify that no pins are bent or deformed.



646



c. Verify proper crimping as described and illustrated in Figure 1.



^ Pin/terminal must be crimped onto the wire (Figure 1, A).



^ Pin/terminal must be crimped onto the wire sheathing (Figure 1, B).



2. Mechanically check the contacts on the control module and connector.



Test the individual terminals by using the standard 0.63 mm male pin (see Figure 1 and Parts Table) to verify proper contact. Make sure that the



test pin is not twisted and is inserted correctly into the female terminal. The contact must be tight, but it must still allow the pin to slide into the



terminal of the control module connector.



Only use the 0.63 mm male pins because the female terminals are designed for these pins, which are the only terminals found in the connectors for



the above-mentioned control modules.



3. If the pin/terminal is deformed, improperly crimped or does not contact correctly, the contact must be replaced with the VAS 1978A repair kit or



ordered in sets.



WARRANTY



This TSB is informational only and not applicable to any Audi warranty.



REQUIRED PARTS AND TOOLS



ADDITIONAL INFORMATION



All parts and service references provided in this TSB are subject to change and/or removal. Always check with your Parts Department and service



manuals for the latest information.