Audi Side Assist(R) - Control Unit Replacement
96 Audi Side Assist, replacing control units
96 11 17
2024300/2
February 23, 2011.
Supersedes Technical DIAGNOSIS AND REPAIR Group 96 number 10 - 11 dated September 7, 2010 for reasons listed below.
367
AFFECTED VEHICLES
CONDITION
A control unit for the Audi Side Assist system (diagnosis address 3C) J769 or J770 has been replaced based on previous diagnosis.
TECHNICAL BACKGROUND
Due to the number of software and hardware versions of the control units, the latest version may not always be supplied by the Parts Department.
PRODUCTION SOLUTION
Not applicable.
SERVICE
1. To avoid repeat repairs, check the following list to determine if the master and slave control units are at the latest software level. Ensure that only
control units with a software version lower than those listed in the table are updated.
Note:
It is possible that higher versions can be flashed with old software during this update.
2. Follow all instructions in the attached TSB 2011732 00 Software Version Management (SVM), operating instructions.
3. Update the Side Assist control units (J769 and J770) using the SVM action code as listed in the table above if necessary.
368
WARRANTY INFORMATION
ADDITIONAL INFORMATION
The following Technical DIAGNOSIS AND REPAIR will be necessary to complete this procedure:
^ TSB 2011732 00 Software Version Management (SVM), operating instructions.
All parts and service references provided in this TSB are subject to change and/or removal. Always check with your Parts Department and service
manuals for the latest information.
ATTACHMENTS
369
370
371
372
373
374
375
TSB 2011732 00 Software Version Management (SVM), operating instructions.
