Audi Q5 Technical Service Bulletin # 851208 Date: 120817
Interior - Passenger Floor Mat Is Wet
85 Passenger floor mat is wet
85 12 08
2029243/3
August 17, 2012.
Supersedes Technical Service Bulletin Group 85 number 12 - 06 dated May 14, 2012 for reasons listed below.
Affected Vehicles
Condition
Customer may report the front of the passenger floor mat is wet after heavy rains.
Technical Background
The flat surface of the fresh air intake may warp over time and cause a gap where it meets with the plenum wall.
During heavy rains, water can back up and enter the vehicle through this gap.
Production Solution
The torque value and tightening sequence of the three mounting nuts have been optimized for production.
Service
1. Remove and install the fresh air intake according to the repair manual.
Heating, Ventilation & Air Conditioning >> Heating, Ventilation & Air Conditioning >> 87 Air Conditioning >> Removal and Installation >>
Fresh Air Intake
2010 Audi Q5 Quattro (8RB) V6-3.2L (CALB) Page 32
2. After the plenum cover and fresh air intake grill have been removed, and before removing the fresh air intake, verify the customer complaint
by applying water to the top surface where the fresh air intake meets the plenum wall using a hose. Visually check for water leaking into the
blower intake. (Figure 1).
3. Apply a bead of butyl cord around the perimeter of fresh air intake, to the outside of the existing rubber seal. (Figure 2).
4. Verify the repair.
Warranty
2010 Audi Q5 Quattro (8RB) V6-3.2L (CALB) Page 33
Required Parts and Tools
Additional Information
All parts and service references provided in this TSB are subject to change and/or removal. Always check with your Parts Department and service
manuals for the latest information.
Interior - Passenger Floor Mat Is Wet
85 Passenger floor mat is wet
85 12 08
2029243/3
August 17, 2012.
Supersedes Technical Service Bulletin Group 85 number 12 - 06 dated May 14, 2012 for reasons listed below.
Affected Vehicles
Condition
Customer may report the front of the passenger floor mat is wet after heavy rains.
Technical Background
The flat surface of the fresh air intake may warp over time and cause a gap where it meets with the plenum wall.
During heavy rains, water can back up and enter the vehicle through this gap.
Production Solution
The torque value and tightening sequence of the three mounting nuts have been optimized for production.
Service
1. Remove and install the fresh air intake according to the repair manual.
Heating, Ventilation & Air Conditioning >> Heating, Ventilation & Air Conditioning >> 87 Air Conditioning >> Removal and Installation >>
Fresh Air Intake
2010 Audi Q5 Quattro (8RB) V6-3.2L (CALB) Page 32
2. After the plenum cover and fresh air intake grill have been removed, and before removing the fresh air intake, verify the customer complaint
by applying water to the top surface where the fresh air intake meets the plenum wall using a hose. Visually check for water leaking into the
blower intake. (Figure 1).
3. Apply a bead of butyl cord around the perimeter of fresh air intake, to the outside of the existing rubber seal. (Figure 2).
4. Verify the repair.
Warranty
2010 Audi Q5 Quattro (8RB) V6-3.2L (CALB) Page 33
Required Parts and Tools
Additional Information
All parts and service references provided in this TSB are subject to change and/or removal. Always check with your Parts Department and service
manuals for the latest information.
