Audi A4 Quattro Sedan # 661115 Date: 110718
Body - Wind Noise From Door Mirrors
66 Wind noise from the exterior rear view mirror housing
66 11 15
2026976/1
July 18, 2011
363
Affected Vehicles
Condition
Wind noise heard by the customer at highway speeds.
Technical Background
Air flows through the exterior rear view mirror housing at the seam where the turn signal lamp meets the housing. This causes a high-frequency
whistling tone.
Production Solution
A sealing strip is installed in the exterior rear view mirror housing.
Service
1. Confirm through diagnosis that the source of the wind noise is coming from the exterior rear view mirror housing.
2. Install a sealing strip on the cover of the housing, as shown in Figure 1.
3. Perform the strip installation to both exterior mirrors, even if the source of the noise is diagnosed as coming from only one of the mirrors.
4. Remove the cap of the exterior rear view mirror housing.
364
5. Attach a strip of sealing foam tape, Figure 2, (part number 8F0 857 869) in the area of the cover shown in Figure 3. The strip will be the correct
length to extend from the corner of the lip to the angle in the body line; no modification of the strip should be necessary.
Warranty
Required Parts and Tools
Additional Information
All parts and service references provided in this TSB are subject to change and/or removal. Always check with your Parts Department and service
manuals for the latest information.
Body - Wind Noise From Door Mirrors
66 Wind noise from the exterior rear view mirror housing
66 11 15
2026976/1
July 18, 2011
363
Affected Vehicles
Condition
Wind noise heard by the customer at highway speeds.
Technical Background
Air flows through the exterior rear view mirror housing at the seam where the turn signal lamp meets the housing. This causes a high-frequency
whistling tone.
Production Solution
A sealing strip is installed in the exterior rear view mirror housing.
Service
1. Confirm through diagnosis that the source of the wind noise is coming from the exterior rear view mirror housing.
2. Install a sealing strip on the cover of the housing, as shown in Figure 1.
3. Perform the strip installation to both exterior mirrors, even if the source of the noise is diagnosed as coming from only one of the mirrors.
4. Remove the cap of the exterior rear view mirror housing.
364
5. Attach a strip of sealing foam tape, Figure 2, (part number 8F0 857 869) in the area of the cover shown in Figure 3. The strip will be the correct
length to extend from the corner of the lip to the angle in the body line; no modification of the strip should be necessary.
Warranty
Required Parts and Tools
Additional Information
All parts and service references provided in this TSB are subject to change and/or removal. Always check with your Parts Department and service
manuals for the latest information.
