Technical Service Bulletin # 011132 Date: 111026
Fuel System - MIL ON/DTC's P0087/P0192/P119A
01 MIL on, DTC P0087, P0088, P0192 or P119A
01 11 32
2027306/2
October 26, 2011.
Supersedes Technical Service Bulletin Group 01 number 11 - 30 dated September 28, 2011 for reasons listed below.
Affected Vehicles
Condition
^ MIL on.
^ DTC P0087, P0088, P0192 and/or P119A stored in ECM Fault Memory.
One or more of the following codes may be stored in the ECM Fault Memory:
^ P0087 - Fuel Rail/System Pressure - Too Low.
^ P0088 - Fuel Rail/System Pressure - Too High.
^ P0192 - Fuel Rail Pressure Sensor "A" Circuit Low Input.
^ P119A - Fuel Pressure Sensor -G247- Malfunction.
Technical Background
Assistance to properly diagnose a fuel pressure sensor -G247- concern.
Production Solution
Not applicable.
Service
Perform Fuel Pressure Sensor Test; select: Repair Manual >> Engine >> Fuel Injection and Ignition >> 24 Multiport Fuel Injection >> Diagnosis
and testing >> Fuel Pressure Sensor G247, Checking in ElsaWeb.
If the difference between test gauge and "actual" MVB fuel pressure (106/2) on the vehicle diagnostic tester is greater than 5 bar 500 kPa / 73 psi:
^ Test the wiring to the fuel pressure sensor using Guided Fault Finding in the vehicle diagnostic tester.
AUDI A3 QUATTRO Page 100
If the difference remains greater than 5 bar / 500 kPa / 73 psi after wiring test:
^ Replace the fuel pressure sensor.
If the difference between test gauge and "actual" MVB fuel pressure (106/2) on the vehicle diagnostic tester is less than 5 bar 500 kPa / 73 psi, do
not replace the fuel pressure sensor:
^ Select: Repair Manual >> Engine >> Fuel Injection and Ignition >> 24 Multiport Fuel Injection >> Diagnosis and testing >> Fuel Holding
Pressure, Checking with High Pressure Pump.
^ Consider mechanical failure of the high pressure fuel pump or intake camshaft. The Technical Assistance Center (TAC) can assist with further
diagnosis.
Warranty
This TSB is informational only and not applicable to any Audi warranty.
Additional Information
All parts and service references provided in this TSB are subject to change and/or removal. Always check with your Parts Department and service
manuals for the latest information.
Technical Service Bulletin # 941154 Date: 111012
Lighting - Halogen Daytime Running Lamps Inoperative
94 Halogen Daytime running lights do not work
94 11 54
2017488/5
October 12, 2011.
Supersedes Technical Service Bulletin Group 94 number 10 - 38 dated October 20, 2010 for reasons listed below.
Affected Vehicles
AUDI A3 QUATTRO Page 101
Condition
Daytime running lights do not work on vehicles with halogen DRLs.
For vehicles with LED DRLs, please reference TSB 2027773, 94 LED Daytime Running Light Diagnosis Tips.
Technical Background
The thumb wheel or option for daytime running lights is turned off by mistake.
Production Solution
Not applicable.
Service
A3, A4 (8E), Cabriolet, TT:
Check whether the daytime running lights thumb wheel is switched on. The DRL thumb wheel is located next to the light switch. On vehicles without
a DRL thumb wheel, the DRLs are activated through the main headlight switch, by switching to DRL.
A4 (8K), A5, A6, A8, Audi Q7:
In vehicles with MMI, the daytime running lights are switched on via the menu option Exterior light control or Exterior Lighting.
See also the owners manual of the respective vehicle types.
Warranty
This TSB is informational only and not applicable to any Audi warranty.
Additional Information
All parts and service references provided in this TSB are subject to change and/or removal. Always check with your Parts Department and service
manuals for the latest information.
