ALL VEHICLES - SOFTWARE UPDATING TIPS
TECH TIPS - CANADA
Reference Number(s): CTT 01-14-02, Date of Issue: March 24, 2014
SERVICE INFORMATION
All Vehicles - Software Updating Tips
For concerns with updating software on all modules follow tips below:
When using the VAS 6150, t or 6160A scan tool to perform a SW update, be sure to
have the USB cable attached to the scan tool for the data link connector. Any
interruption in the communication of the Bluetooth connection can cause the flash
to fail, so a hard line is recommended.
Make sure the battery voltage is maintained above 12.5 volts using a charger.
Make sure the shifter is in park when performing the flash.
If the flash fails, try selecting a different carline with similar module and use
the same unit code (If through SVM).
An error code 800.11 means wrong test plan or unit code was selected. Double check
the selection, and retry the flash.
If an ECM flash fails before replacement of the ECM, check the status of the MIL light.
If the MIL comes on, then the ECM is not damaged. Disconnect the battery for 30-60
minutes, and then retry the flash again.
AUDI: All Models
GROUP: 01 - On-Board Diagnostic
2004 Audi A6 Quattro
ALL VEHICLES - SOFTWARE UPDATING TIPS TECH TIPS - CANADA
2019年10月9日 20:1 12:006 Page 1 © 2011 Mitchell Repair Information Company, LLC.
TECH TIPS - CANADA
Reference Number(s): CTT 01-14-02, Date of Issue: March 24, 2014
SERVICE INFORMATION
All Vehicles - Software Updating Tips
For concerns with updating software on all modules follow tips below:
When using the VAS 6150, t or 6160A scan tool to perform a SW update, be sure to
have the USB cable attached to the scan tool for the data link connector. Any
interruption in the communication of the Bluetooth connection can cause the flash
to fail, so a hard line is recommended.
Make sure the battery voltage is maintained above 12.5 volts using a charger.
Make sure the shifter is in park when performing the flash.
If the flash fails, try selecting a different carline with similar module and use
the same unit code (If through SVM).
An error code 800.11 means wrong test plan or unit code was selected. Double check
the selection, and retry the flash.
If an ECM flash fails before replacement of the ECM, check the status of the MIL light.
If the MIL comes on, then the ECM is not damaged. Disconnect the battery for 30-60
minutes, and then retry the flash again.
AUDI: All Models
GROUP: 01 - On-Board Diagnostic
2004 Audi A6 Quattro
ALL VEHICLES - SOFTWARE UPDATING TIPS TECH TIPS - CANADA
2019年10月9日 20:1 12:006 Page 1 © 2011 Mitchell Repair Information Company, LLC.
